|
| |||||||||||||||||
1" high frequency compression driver. Low mass mylar diaphragm ensures an extremely flat frequency response and optimized ceramic magnet assembly, results in high sensitivity and low distortion up to 18 kHz.
Specifications1
- Throat Diameter 25 mm (1 in)
- Nominal Impedance 8 Ω
- Minimum Impedance 7.7 Ω
- Power Handling(2200 –20000 Hz)
- Nominal2 40 W
- Continuous Program3 80 W
- Sensitivity (1W/1m)4 108.5 dB
- Frequency Range 1.5 – 18 kHz
- Recommended Crossover5 2.2 kHz
- Voice Coil Diameter 44 mm (1.7 in)
- Winding Material Aluminium
- Inductance 0.11 mH
- Diaphragm Material Mylar
- Flux Density 1.7 T
Mounting and Shipping Information
- Two M6 holes 180° on 76 mm (3 in) diameter
- Three M6 holes 120° on 57 mm (2.2 in) diameter
- Overall Diameter 134 mm (5.3 in)
- Depth 60 mm (2.4 in)
- Net Weight (1 unit) 2.8 kg (6.2 lb)
1 Driver mounted on B&C ME 45 horn.
2 2 hours test made with continuous pink noise signal (6 dB crest factor) within the specified range. Power calculated on rated minimum impedance.
3 Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
4 Applied RMS Voltage is set to 2.83V for 8 ohms and 4V for 16 ohms Nominal Impedance. Average SPL from 1000 to 18000 Hz.
5 12 dB/oct. or higher slope high-pass filter.
| Other B & C products similar to B&C DE25 40W 8 Ohm 1" Bolt On Compression Driver : |
|
||
|
|
Martin Audio DCD025 DCD025 | Tweeter | Original
Martin Audio H3 DCD025 | Tweeter | Original
Our database of parts includes a wide range of products, and in many cases offers cost effective alternatives for repair. Alternatives are loosely grouped into three types:
Original - Usually an exact match to the original product, and just the 'standard' part from the factory which gets rebadged by manufacturer with their own brand and part number. Occasionally, there are subtle tweaks made from the standard part, but its virtually impossible for us to determine this. If we have listed the part as Original, it means we are confident the performance is the same.Aftermarket - Aftermarket parts often become available from factories in the far east once the original part is no longer manufactured. They are intended to be a close match, and provide a cost-effective alternative.
Equivalent - These are alternative options, which provide very similar performance, but are not the same as the original. In some cases the performance may actually be improved. We have used both our own experience, and feedback from customers in generating list of alternatives. Alternatives like this are useful when the original part is no longer made, there is no aftermarket option, so the only choice is to upgrade with the nearest current equivalent product.