Fed up of wasting time wiring up links on speakons?
We were too...
So we created this handy little PCB which lets you quickly and easily link all pins on a pair of Neutrik NL4MP, with the option to mount a 4 way screw terminal block, or just solder 2.5mm wires directly to the PCB. Depending on your tools, we estimate that this can bring down the assembly time of a speakon panel down to under 2 minutes, whereas stripping back link wires and direct soldering can typically take up to 10-15 minutes, a MASSIVE
time saving if you're building batches of speakers.
You can secure wires with a cable tie using one or both of the slots cut into the PCB.
Price is per PCB - there are two in the image to show front and back.
The first image show both sides of the PCB - it is a double sided PCB, and the side with the white silk screen print is where the pins of the speakon stick through. You should be able to see the pin identification on the PCB when soldering.
The second image is for illustrative purposes to show a finished configuration - terminal blocks and speakon connectors ARE NOT INCLUDED
and must be purchased separately. There are also two sets of solder pads suitable for wire of up to 2.5 sq mm
The third image show the complete assembly with the speakon sockets mounted on a recess dish using M3 nuts/bolts. For a secure quick mounting the Neutrik MFD
mounting accessory is highly recommended.
The spacing between connectors on this PCB is designed to match up perfectly with our twin speakon dish: TUFF87160 - Large Recessed Steel Connector Plate for 2 x Speakon
or alternatively you can use this on your own panels with the spacing between the speakons at 40mm.